- Industrial
- Automatic Paper Testing ( Autoline Profiler )
- Color Measurement Instruments
- Electro Analyzer
- Gas Analyzers
- Industrial Textile Treating Systems
- On-Line Chemical Analyzers
- Package Quality Testing Instruments
- Paper & Board Process Optimization Instruments
- Paper Testing Instruments
- Petroleum Testing Instruments
- Pulp Testing Instruments
- Sieve Shakers / Sieves
- Laboratory
- Amino Acid Analyzers
- Autoclaves
- Balances
- Baths and Circulators
- Bio Reactors / Fermentors
- Blenders
- Block Heaters
- Calibration Equipment
- Calorimeters
- Centrifuges
- Chromatography
- Conductivity Meters
- Deep Freezers / Freezers
- Electrical Test Equipment
- Electronic Test Instruments
- Electrophoresis and Accessories
- Flowmeters
- Fraction Collectors
- Furnaces
- Glassware Washers
- Heating Mantles
- Homogenizers
- Hot Plates
- Incubators
- Ion Meters
- Liyofilization (Freeze Drying) Instruments
- Magnetic Stirrers
- Melting Point Apparatus
- Microplate Readers
- Microscopes
- Mills
- Mixers
- Moisture Analyzers
- Organic Synthesis Systems
- Ovens
- Oxygen Meters
- pH Meters
- Photometers
- Polorimeters
- Presses
- Pressure / Vacuum Meters
- Pumps
- Reactors
- Recorder and Dataloggers
- Refractometers
- Rotary Evaporators
- Salinity Meters
- Sample Preparation Bombs
- Shakers
- Spectrophotometers
- Sterilizers
- Temperature Controlled Heating & Cooling Systems
- Temperature Measuring Instruments
- Thermocycler (PCR)
- Thermohygrometers
- Ultrasonic Cleaners
- Vibration / Leak Detection Instruments
- Viscometers
- Water Purification Systems
- Water Testing Instruments
Remote Flowmeters
Remote Flowmeters
 |
Search through our selection of Flowmeters-FAST |
 |
Adjustable and spannable 4 to 20 mA output signal
|
| This highly flexible design makes for easy integration into complex system layouts. These flowmeters provide a 4 to 20 mA output through a remote module in addition to offering a local flow display on the turbine sensor or on the remote transmitter. The 4 to 20 mA output signal is adjustable for tuning of high and low endpoints to specific process parameters, including a minimum or maximum anticipated flow. The electronics have been designed for low power consumption and the output signal is loop powered, simplifying wiring requirements at installation. All meters measure flows linearly across the range. The display shows flows in GPM or LPM, in addition to showing both permanent and resettable totals. A six-digit display automatically turns on when flow starts then turns off four minutes after flow ceases. Flowmeters are ideal for use in manufacturing plants, research and development facilities, or quality control facilities. Install meters in either a vertical or horizontal position. For best results, install within a straight run of pipe at least ten pipe diameters long on inlet side and five on the outlet side. Wetted materials are the sensor selected housing, PVDF rotor and supports, tungsten carbide shaft, 316 SS retainers, and ceramic bearings. We recommend an inlet filter or screen to reduce impurities from incoming fluids. See the �Process Filtration� section. All flowmeters come with a 20-ft pre-attached cable between the flow sensor and the 4 to 20 mA output module. Other cable lengths may be ordered�contact our Application Specialists for details. |
|
To see all products and details in this product range click here-->>>
« Flowmeters
